Trailer Hitch Installation - 2007 Buick Rendezvous - Curt C55383- Video

All right, today on this 2007 Buick Rendezvous we're going to show you the Curt T-connector vehicle wiring harness, part number C55383. With this part number, this is what you get, obviously your wire harness and two T-connectors. Yellow wire T-connector goes to driver side. Green wire T-connector goes over to the passenger side. You've got a nice long length of wire that will reach from one side to the other and this is our four pull flat. When a four pull is not being used it comes with a cover for it as well, plus, some zip ties and screw for the ground. more

Watch Video

6/30/2015 2:02:02 PM

Trailer Wiring Harness Installation - 2005 Buick Rendezvous- Video

Today on our 2005 Buick Rendezvous we're going to be installing the Tow Ready T-One Vehicle Wiring Harness with a 4-pole Flat Trailer Connector, part number 118383. We'll begin here at the rear of the vehicle. We'll need to open up the rear hatch. Next we're going to need to remove a few interior panels to gain access to the taillight wiring. We'll begin over here on the passenger side. We'll need to remove this little cover here by simply lifting up on the tabs, gently pulling out and then set that one aside. We'll go ahead and repeat that same process over here on the driver side. Next we're going to need to remove this rear threshold piece. more

Watch Video

10/13/2014 12:16:35 PM

Trailer Wiring Harness Installation - 2004 Buick Rendezvous- Video

Alright, today on this 2004 Buick Rendezvous we're going to install part number 41405 from Hopkins. This is a wiring harness that plugs in to the factory towing port. First, we'll go ahead and locate the port. It's underneath the vehicle, on the driver side, above the suspension in the corner by the bumper. We'll go ahead and use a trim panel tool to remove it from the sheet metal underneath then we'll go ahead and remove the cap. There's a small tab we need to pull up then it comes right apart.Now we'll take our new wiring harness, we'll add some dielectric grease that comes with it to the terminal then we'll go ahead and snap it into place. more

Watch Video

1/29/2013 8:42:52 AM

Trailer Wiring Harness Installation - 2003 Buick Rendezvous- Video

Today on this 2003 Buick Rendezvous were going to install part number 118383 from Tow Ready. The first thing we need to do is go ahead and open up the hatch and remove the two taillights and disconnect the electrical from them. With the lights removed well go ahead and loosen up the wire harness that goes into the body. Pull the grommet out and move it to the side for now. Next well go on the interior of the vehicle and well remove the floor coverings, the threshold and loosen up the panels on the side. Now we can go ahead and start installing the wire harness. more

Watch Video

1/25/2013 3:14:13 PM

Trailer Wiring Harness Installation - 2006 Buick Rendezvous- Video

Today, in our 2006 Buick Rendezvous, we're going to install the Tow Ready T1 Connector part number 118383. We'll start by opening up the rear cargo door to access the rear cargo area. And then we're going to remove the access panels on both sides. There's access panel for the passenger side. We'll repeat the same process on the driver's side. Next, we need to remove the rear threshold. more

Watch Video

4/19/2012 12:38:12 PM

  1